Posted by Determined on November 28, 2015 at 09:02:26 from (216.130.212.127):
In Reply to: grapple cylinder posted by rick1 on November 27, 2015 at 15:02:04:
Quoting Removed, click Modern View to see
Only problem I have run across with a shorter stroke cylinder is
if your geometry is not proper there can be a tremendous amount of leverage applied back to the cylinder.
For example you forward tilt with a load in the bucket and the load catches on something.
Had to redesign one I bought that was set up for round bales, 5-5 1/2 foot bales it handled all day long as soon as you would try to stack/load a 6 foot bale the design of it would allow it to kick over center on the pivot point which would tear up cylinders so bad you would think they were made of plastic.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
