Mark, "I'm guessing the fill valve control goes through the heating element so the ice maker can't activate the fill valve if the heater fails." If you could see the ice maker's circuit diagram you would see your guess is wrong. If the heater is on, the end the control valve that will be fed power through the heating element is connected to neutral, both wires going to valve are are then connected to neutral. So no water can be added while heating element is on.
"Generally, the problem will be with the fill valve, with hard water blocking the valve or causing it to stick." All the water going to ice maker on this refrigerator goes through a filter inside refrigerator. Generally well water has a little dirt or sand which the filter removes. At my other home, the refrigerator was purchased in 1992, it has ice maker, hard water, no filter and still no problems like I just had.
By adjusting the screw 2 turns to the + side, I now have larger cubes. It's working perfectly. Post back if I ever have any more problems.
Up date on 4010 mule. The thermistor I made works better the colder it gets. Been using 93 octane. The mule runs better than it did when new. NO holes in piston.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
