Bill most offset hitches are welded on the left side of the bumper not anywhere near the receiver hitch. I actually had a truck with an offset hitch. It was not that much of a help. All it did was center the pulled implement behind the truck. I soon found out that was not such a good idea for several reasons. 1) You can not see behind the towed implement. When your centered all you can see out your mirrors is the implement. 2) IF you do have to get over when you meet oncoming traffic you may have to have the truck clear off the road with an offset hitch. With the regular hitch you can usually just let the Implement go off the road. 3) Oncoming traffic will see the truck better than some corner of a towed implement. I like head lights and flashers out towards the center line not in the middle of the towed implement. 4) With an offset hitch your "guessing" where both side of the towed implement are. Most implements will line up pretty well on the left side of your truck when you pull them.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
