Posted by Greg K on December 21, 2015 at 18:29:47 from (70.197.206.244):
In Reply to: Lennox pulse furnace posted by Greg K on December 21, 2015 at 16:16:59:
Ok. Here is where I'm at now. The heat pump seems to be working since I turned the thermostat call for heat temp down to within a degree or two of the room temp, then I slowly increased it a degree at a time so it could keep up. As of the last attempt it still would not work on the propane side. I removed the intake pipe (wasn't glued) from the furnace in case it was blocked. I pulled the plug from the condensate at the bottom of the exhaust in case there was any blockage there, however no improvement. There is 700 gallons of propane so that should be sufficient. When I removed the line inside I had gas pressure that I could stop with putting my finger over the pipe. I poured boiling water over the regulator in case it had some ice in it. I tapped on the electronic gas valve in the furnace in case it was sticking. I'm out of ideas for me. My friend said if he can he'll stop by tomorrow. Thanks for the input, I remind me of the joke of two guys meeting in mid air. The one going down asks the other one "do you known anything about parachutes?" And the other one replies "no, do you know anything about gas stoves?"
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Price Enthusiasm? - by Anthony West. Quite frankly, for some time now restorers like myself have become more and more concerned about the rapid increase in the prices of old farm machines here in England. There is now a growing market for "As found" machines. Which as machines get rarer, has found the birth of a new industry....one of the "procurement agent". These agents appropriate as much old machinery as possible then inflate prices at auctions. So at what price enthiusiasm? We are now seeing poor machines which 3 years ago ma
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.