Posted by fixerupper on December 27, 2015 at 05:34:24 from (100.42.83.79):
In Reply to: Spare Parts posted by 37Chief on December 26, 2015 at 18:08:56:
Chief you need not feel alone. I had the same experience trying to find some rod bearing shims the other day. I ran out of shims and I knew I had more somewhere but I couldn't put a finger on them. I keep my shop neat and clean but still I couldn't come up with them. Since I was out of shims and couldn't finish the rod bearings I dug into the magneto. Wasn't long till I needed mag parts so I headed to the barn where I have a Rubbermaid tub full of mag parts. When I opened the lid on the tub my eyes fell on a yogurt tub labeled F20 ROD SHIMS! Boy was I a happy camper. LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
