Posted by showcrop on January 03, 2016 at 05:56:22 from (66.31.196.130):
In Reply to: Lowering a roof posted by notjustair on January 02, 2016 at 19:18:18:
When I needed to shore up a corner of the foundation of my post and beam barn I needed of course to take the weight off with no good bearing surface available. I drilled two one inch holes through the post and using all thread I secured a piece of full 2x4 inch hardwood vertically to the post. This gave me a purchase point for my forklift. You could attach vertical pieces like I did to your posts, using as many through bolts as needed for the weight. Then use the verticals to rest on horizontal adequately beefy planks going out two feet to each side. This gives you a purchase point near the ground, so then you can take the weight off the posts with a little cribbing and a couple jacks. Then you could cut the deteriorated part off the poles, build a form and pour a concrete block with the steel attachments that they make to go into the concrete,to make a footing for each one, then lower the post back down to it. You could do them one at a time working safely on the ground. It would be a good idea to install two cable or chain safety braces from about ten feet down one post, diagonally up to the roof eaves member to eliminate the tendency that you say that it has now to lean. Once you have it on its new bearings you could install permanent wood or steel diagonal braces. If you think that this looks viable but is not entirely clear post back and maybe I can describe parts a little better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.