We used to pull a 4-16 moldboard plow with a new or several year old Farmall gas 706. I couldn't believe how hard we worked that tractor. I was only about 11 when we got the first one, so the first things I used it for were disking and harrowing. The first time I got to plow was the first time I ever ran something that did not run full throttle. Dad told me to run it in low 4 and we should have probably run it a gear lower. I think it was running about 1800 rpm or a little less. It had 16.9 x 34 tires on it. I found out later that the tire size made a difference in speed. The speed chart by your feet, said the speeds were with 18.4 tires. I don't know whether they were 34 or 38 on the chart. I figured out later that the 18.4 tires were probably for an 806 and IHC was cheap and didn't put an appropriate decal on the tractor according to what the tire size was installed on them. If I remember running it at that load (the worst example) we only got about 3000 hours before a complete overhaul was expected. We were farming about 400 acres and probably plowing about 250.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.