Thanks for all replies. I have things to check now. Adjusters were disassembled and lubed with anti-sieze. All other parts in rear were either cleaned or replaced with new. "Determined", I will have to pull the drums to check the linings. I did verify that the steel shoe frames were identical, but didn't pay attention to see if the new linings are all the same or different. I just went out to the garage to look at the core linings, and can't tell where the linings ended as large parts missing and rusty. Drums were not machined or replaced. No apparent damage, probably the best looking ones I have seen in a long time. "Super H" I will check on your suggestions, almost positive 4 wheel ABS. "Marlynr" Calipers were not removed, only worked on the bleeders to free them up. They are on top. T in NE. This is a 94 Dodge. The rear brake technology is 70's. There are two types of self adjusting drums. This type has the adjusters clear at the bottom and are activated by a lever that pivots off of a pin on the rear shoe. There is a newer design where the adjuster is above axle center and is connected with the parking brake cable. "Steve: hard pedal ineffective, sometimes locks one front wheel when chattering. Previous to working on it this winter, it did not ever lock up.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
