Posted by DFZ on February 10, 2016 at 16:49:46 from (184.100.185.44):
In Reply to: Tire Help posted by makoman on February 10, 2016 at 15:33:23:
I have a cheat method that I have been using with great success recently.
I prefer to work the tire off the tractor. Once I get the tire dismounted that much, with a gap between tire and rim I wrap a strap around the tire, through the gap you have with the bars. Then I use another strap around the rim and pull opposite directions. I usually anchor the rim to a stationary tractor and the tire to our forklift or loader tractor. I find if I can pull near horizontal with the rim, and pull as steeply downwards on the tire it pulls right off. LUBE IT WELL. GO VERY SLOW. Steady pressure and it rolls right off. Make sure the bottom bead is in the deepest well of the rim and closest to the lip you are pulling it off.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
