Posted by Ron-MO on February 11, 2016 at 10:22:28 from (108.171.131.170):
In Reply to: Jobs going to Mexico? posted by Spook on February 11, 2016 at 07:55:44:
Labor costs are a factor, but as others say, not always the only factor. I know the plant I used to work for was part of another manufacturing company that was purchased. The plant I worked for built the same basic product as a few other facilities they already had, so the handwriting was on the wall, and one very large plant that built that same product was in Mexico. It took about 3 years to roll that plant into existing plants across the US and Mexico, and the term is "synergies". As much as it hurts the US worker, and US economy, it makes no sense to make a product in more than one location and duplicate efforts, therefore they identify the least cost method or location, and move the existing process or product to that location. Ironically part of the close of that facility moved jobs to another US plant, and in fact I can think of one such process that has moved twice - two times for plant closings. Each time they closed a plant where that machine or process was. Since this machine does not produce high volume it is very likely it will remain in the US in one of their plants. It is well known that low volume or processes that require high set up times (requiring more machine set up), do not lend well to Mexican plants.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.