Have the Husker for a picture. Have load of second crop that we saved to got the clover huller out a few years ago. Never did, so by now the mice likely have all the seed out of it.
Now for a story. I went into the local farm museum one day, while I was looking around a group of women came in. I overheard their conversation about the equipment, so I went over and started talking to them and answering questions about what the stuff was. Some pieces of mention(in said conversation) were the clover huller, thrash machine, fanning mill and feed cutter.
I had just brought in a bag full of alfalfa seed(for those that don't know alfalfa and clover are about the same size, and can be thrashed out with clover huller) we thrashed out a short time before, and showed them. They were amazed that such a large machine could separate such a small seed(same with thrashing machine).
Next was the feed cutter, told them it was for the same thing as the choppers running down the field, just stationary, and could run anything you wanted though it(corn, hay, straw). They had a good time when they left I heard them tell the actual volunteer there that they should have me back more often. Never did find the time to sneak back in to there though.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
