Posted by Andy Martin on February 16, 2016 at 18:21:56 from (209.213.149.120):
In Reply to: Hyd leak? posted by old-9 on February 16, 2016 at 17:02:58:
Dope should be used to lubricate the threads, not really to seal them. If the street ell threads look good, you may find they are cut too long. Try grinding the end of the male part of the ell if it looks like the threads may be bottoming out. If the thread is short you might try using a pipe die on it to cut a little more thread to allow you to get another turn. I had a bunch of pipe fitters threading 2" pipe one time, and I could tell they had cut the threads too deep, and told them so. They knew I wasn't a pipe fitter so knew nothing until all their joints leaked because the threads bottomed out before sealing.
Otherwise, get a close nipple and a conventional ell, you'll have two joints to help with the number of turns to get it tight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.