Posted by jimg.allentown on February 22, 2016 at 14:58:52 from (108.16.40.179):
In Reply to: Re-Torquing head bolts posted by JRSutton on February 22, 2016 at 07:05:18:
In EVERY case, the manual takes priority. What is told by the people that made the engine should be regarded as the LAW. So, having said that, I will add just a few points of information..... Unless instructed to do so, re-torqueing a warm engine is not advised. The main reason is how to tell just HOW warm it "should" be. While the bolts DO expand and lengthen when warm, so also does the surrounding material like the block and head. Overall, it should be a net zero result. NEVER, NEVER, EVER re-torque stretch bolts. These are torque to yield bolts, and once yielded, are meant to remain as they are until the next time a head is removed. And then they are meant to be replaced. When re-torqueing, I would personally recommend loosening a few degrees first, then re-torque. The initial force required to start the bolt turning can exceed the torque that has been applied to the bolt. This results in an inaccurate torque reading. In EVERY case, the procedure given in your manual for that machine is the gospel truth for that machine. Whether it be an engine, a transmission casting, a bearing housing, or whatever. Also, know that the accuracy of the torque to the inch-pound is not nearly as important as the UNIFORMITY of the torque. Uneven torque causes metal castings to warp. Evenly tightened castings will generally live longer as a rule.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
