Not mechanical, but one of the worst jobs I ever did was going down into the east cell house at the then Joliet Prison after a sewage pipe broke and over a period of time flooded it with about a million gallons of raw sewage, which is why all of the phones went dead. The open cable got flooded and shorted out. I went out there, knew about the splice down under the cell house. They opened the hatch to the basement, and there was raw sewage almost completely up to the floor, and the basement was 10 feet deep. I'm guessing the length of about 300' and a width of about 100' by 10' deep. That's a lot of raw sewage and I told them no way, pump it and clean it out. I came back the next day, they had it pumped out, but not cleaned. I suited up in boots, rain gear, rubber gloves and went down into the biggest septic tank I can imagine, found the splice, cleaned and redid it as best I could, got the phones working. Lots and lots of mosquitoes down there. I figured I'd come down with hepatitis or AIDS if one of them had bitten on of the infected inmates before biting me. All in all, was one crappy job.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.