Posted by RBoots on April 16, 2016 at 19:22:56 from (173.241.113.102):
Any of you that own an 86 series IH probably know how stupid the connection between the hyd control lever and the actual control valves is. I need to reseal the control valves on our 1086, and decided to find a better way to make a replaceable connection that wears itself instead of the actual spool of the control valve. I found these little ball joints in the McMaster-Carr catalog. One has a 5/16 hole in the ball, and the other has a 1/4" hole in the ball. One has 5/16-24 externally threaded shank, and the other has 5/16-24 internally threaded shank. I just added the nut to lock the two into position. The hole in the spool was worn enough that a 1/4" bolt will go through it, and the hole in the bottom of the lever has a 5/16" hole where the clevis pin went through. So, when bolted tight against the spool and the lever, the ball itself will pivot. The cost? About $16 to fix both valves on the tractor, so I bought enough to do our 1086 and 1486, cost $38 with shipping. Much better, no more sloppy levers.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.