In WWII, the Army Air Corps noticed that every squadron had several pilots who were far more effective at shooting down enemy airplanes than the rest of the pilots. They set out to see if they could find a commonality between the highly effective pilots.
They looked at personality. Nothing. An aggressive, gregarious pilot might not be better than a quiet, introverted man.
Education? A highly educated pilot might not be more successful than one who barely met the minimum education requirements to be a pilot.
Physical stature? Didn't make any difference.
They finally figured it out. Almost all of the pilots who were highly successful at shooting down enemy airplanes were farm boys from the Midwest. They grew up shooting pheasants and ducks on the wing, and when in a fighter plane shooting at an enemy plane they instinctively built in the proper elevation and azimuth lead angles.
Kinda interesting. But, you have to realize that in those days a gun sight in a fighter plane may not have been anything more than an "X" drawn inside the windshield with a grease pencil.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
