The starter checks out fine. I know the issue is the push-button switch. The first switch was something I robbed off a truck salt-spreader that has a 18 HP Briggs & Stratton engine with a 12 volt battery. So I assumed that switch was low amp and made for 12 volt. But the news one I've bought - advertised to be made for 6 volt farm tractors like Case and IH - is the same size and only rated 100 amps which is WAY too small. The starter when new is supposed to draw around 250 amps @ 4.5-5 volts when cranking. Obviously if the switch cannot pass that much amperage, much gets lost to heat (and it DOES get hot fast). Considering all the reproduction parts on the market for old tractors - I am somewhat amazed that no one sells an adequate push-button switch anymore? I guess I will wire it for an electric solenoid like Ford and Ferguson uses. Those are rated for 200 amps and that still falls short - but at least is twice what the push-button switch is. This is kind of ironic in a way. My little Cletrac is the last tractor I own still has an original 6 volt system. Generator and lights work fine. I needed a new battery this spring and was very temped to put an alternator on it and change to 12 volt. But - I kind of like having it original since it all works.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.