Posted by Galen Houk on May 09, 2016 at 18:21:57 from (173.22.155.115):
In Reply to: Re: dayshavoo posted by johnpop1 on May 09, 2016 at 16:20:19:
When I am driving semi or gooseneck I just ignore them. If they hit me, they will get 99% of the damage. When I am driving the pickup or car I pull over if I have to and get them to pass. That being said, it really gets my goat when people drive 5 to 10 mph under the speed limit and you can't pass. They need to respect other peoples time even if they are in no hurry themselves. Another thing that annoys me is a farmer driving 18 mph down a very busy highway posted at 60 mph. I had this happen the other day. He drove about 6 miles with 10 semis and 20 cars creeping along behind him. It was a JD 4020 and grain drill. Several people took their lives into their own hands passing. He went past about 20 roads and approaches where he could have pulled over and let traffic clear. He came from a road on the right and eventually turned right. There is a parallel gravel road that would have been just a fast for him. I drive tractors on highways fairly often but I watch the traffic and pull over if I am holding people up. At some places of work you can get fired if you are late three times in a year. Everyone just needs to be considerate of others and all will be well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.