Posted by Oregon Tractor Jack on May 30, 2016 at 11:55:44 from (98.232.236.177):
In Reply to: Farmall H fan belt posted by Larrys on May 30, 2016 at 10:02:02:
Patience is your best tool for getting the fan pulley loose. I would use either Kroil or a mixture of ATF and acetone to soak the set screw. If you use the ATF/acetone mixture, it is like oil and water. It doesn't stay mixed so you have to shake it up constantly. The acetone will "pull" the ATF into the threads. While you are there liberally spray the out side of the pull where the threads are. Let the whole thing sit for several days and reapply at least once a day. It will come out! Once you get the screw out, you most likely have the tap the flat face of the set screw boss to get the pulley to turn. I have 5/8" by 8" brass drift that I use to do this. You might want to put some soap and water on the pulley and the belt also to ease removal. I have three H's that I have had to do this procedure on and it does work.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
