I just cannot imagine any "Pellet Gun" being capable of taking Ground-Hogs reliably..
I, too have used my Mossburg .22 LR for many years, but the ranges seem to have increased and anything over 75-80 yds is pushing a .22 LR.
I have a Savage .17 cal HMR that is very good out to more than 150 yds if the wind is not bad..but I find results greatly improve if you sand the Tip to get a flat tip about 1/16" wide improves results Greatly..( NO Runaways)..!!!
I also Love my .223 Target rifle for Ground-Hogs..I especially like my re-loads with a Full case of 3031 with a 40 gr Ballistic Tip bullet..the 40 gr Ballistic tip will not go through a Ground-Hog..(they never know what hit them)..! At 200 yds, I Love to see the Ground-Hog starting to Flip, BEFORE the gun jumps..!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
