Posted by John T on June 10, 2016 at 20:24:18 from (216.249.76.23):
In Reply to: Electrical help posted by Jubamp;631 on June 10, 2016 at 17:03:04:
For starters, if you feed 120/240 service via a 2 pole breaker in a main panel to a 120/240 sub panel, YOU RUN FOUR WIRES
Two (Red and Black) Hot Ungrounded Conductors
One (White) Neutral Grounded Conductor
One (Green) Equipment Grounding Conductor
At the sub panel, unlike at the Main, the Neutral Buss and the Equipment Ground Busses are kept separate and electrically insulated and isolated from each other. NO Buss to Buss tie bar and NO Neutral to case/tub bond.
The sub panel (depending on where its located) most likely requires connection to a Grounding Electrode.
Typically in wiring devices white pigtails connect to a Neutral Buss and green or bare to the Equipment Ground Buss.
Or wire it as Billy Bob and Bubba tell you lol, electrical or legal questions usually draw more opinions and responses then any other subjects posted here.
John T Too long retired EE and rusty on the NEC so NO warranty
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
