Posted by caterpillar guy on July 04, 2016 at 03:34:18 from (71.10.59.166):
In Reply to: 674 pto posted by pork chop 1568 on July 04, 2016 at 03:06:47:
Our 574 has both shafts. With the shield on there are you sure there is only one shaft? The one in up in that hump in the shield. I think both of ours run at the same time. We don't use ours for PTO work much so don't look at it. I would honestly have to go out and look at it while it ran. I would have to look at our 674 to see if it has both shafts. One possible problem you might run into with the lowered engine speed is the torque and power curves might cause the engine to waver some not keeping your current flow correct. I know my brother wanted to shift up and idle down to plant with the 856 one time. He planted half of a field with half a tank of fuel. I planted the other half with the other half of the tank shifted down and more throttle. I tried running a round baler that way once and didn't like it. Mowing on the other hand worked good that way.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.