Randy I wonder if the local AGCO dealer is doing that too. The trouble is I have had him special order parts and it is still two days minimum. Stock orders are one week. They are a Ford/NH or CNH dealer too so maybe AGCO is getting to be an after thought for them but they were a BIG AC dealer for years.
With JD you can order "Machine Down" orders an you pay the freight but I get the part the next morning even ordering as late as 4 PM the day before here. I can order "stock Order" parts and they ship three stock orders each week. Mon., Wed., and Fri. These stock orders cost you not freight. If I do not need it in a hurry or the parts is heavy I order it "stock order". There is no minimum order amount on a JD stock order.
Brown Swiss: I run into parts at JD that are out of line as well but nothing near as often as I do with AGCO. One of them was just yesterday. I needed a top link for the JD 4020 I just got. It had a rigged up a cheap imported top link. The JD 4020 takes a different link end on the tractor side. I had them order me the complete top link. It was A&I not an issue, $185. I needed the pin that holds it on the tractor. The pin was $26 dollars that's not nice but not terrible. The break over clip pin at $10.95 was NOT expected. That will be going back.
An example of how AGCO parts are pricy too. On an Oliver 1655 you have the "U" shaped cast part that keeps the three point arms from "floating". The are held in with a 3/4 pin with two big washers and a normal break over center Cat.I clip pin. I ordered the cast piece and it was $45. The short 3/4 pin was $52. I made one out of a "new" Cat. I top link pin that cost me $3.95. I just had to shorten it and drill a 7/16 hole in it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
