If theres no voltage on the coils low output (to distributor) terminal: 1) Points closed or shorted or a wire to them or inside dist is shorted,,,,,,,,,,,,,,,,2) Condensor or its wire is shorted,,,,,,,,,,,,,,3) Coils LV Primary is bad/open.
NOTE points are usually closed, so normally there should be no voltage on coils LV output to dist terminal
Unhook the wire to dist and see if theres pass thru voltage on it then with IGN on and voltage on the other high input terminal??????????????? If so but NOT if wire to dist is re attached, again points closed or shorted or condenser or wires are shorted.
Put an ohm meter on coils LV primary + and - terminals, it should read 1 to 3 ohms. If open circuit coil is bad.
Put a test lamp on coils low output to dist terminal and crank engine over. It should flash ON (when points open) but OFF (when points closed)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
