Posted by paul on July 16, 2016 at 05:41:18 from (76.77.197.114):
In Reply to: DOT?? posted by Geo-TH,In on July 16, 2016 at 05:16:55:
I know nothing, but don't you need to tie each corner seperate, so you have 2 chains holding, can cut your requirements in half?
If you need more, add more chains?
From what I hear, dot is just a luck of the draw, every officer has a different personality and reads the many, complicated, regulations a bit differently.....
Was a thread couple years ago on this forum or more likely on NAT where a fella that hauled frequently from north Iowa to west central MN had to stop half way and re chain his equipment, as two districts he passed through saw the rules very differently and got tot the point it was easier to take 15 minutes to re gain than to deal with the questions and different requirements, he was getting targeted because he was always 'wrong' passing through.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
