Posted by Billy NY on July 23, 2016 at 12:47:59 from (104.228.35.235):
In Reply to: DIY shallow well? posted by Moresmoke on July 23, 2016 at 11:23:05:
I've set a 1000'(length) of 18' deep well points before, they do sink in easily when you have them connected to water from a pressurized 12" main.
I'd also not want to dig in that type of soil without retaining the sidewalls, fine sand is no fun to dig in. I've been in one collapse in fine sand myself. I was holding up a phone line with a rope near the cut, a huge chunk fell in with me riding it down. I held on to that rope and was hanging from the phone line as the excavator operator was spinning back around to get another bucket full. I had to dig another co-worker out who was pinned by a big chunk of it against the opposite trench wall, right up to his face. We were installing a new sewer line through sand conditions, 20' deep or so, the job was a disaster from the start, given the way it was done. They finally wised up, got a trench box, well point system to lower the water table.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
