Posted by big tee on July 23, 2016 at 20:05:18 from (199.120.66.137):
I have been working on the 21 ft. table off and on. I built myself a cheap jig out of plywood and 2 x 4's. I tacked them together in the jig and took them out and clamped them to too different things to keep them from warping. You would think I was making rocking chairs instead of picnic table frames. So I straightened the in my homemade press. When I went to the next step and welded the top on I tried something different- I clamped a 5/8ths washer between the part being welded and the stiffener---WORKED!!! Kind of like those big cement I-beams you see going down the road--pre-stressed. I am not used to welding all this new steel. Usually I have to grind of the rust or old paint before I can weld on it. New steel is getting very EXSPENSIVE. My Wife's brother runs a welding/repair shop 15 mi from me so I get my steel from him. 48 ft. of 2x2 1/8 wall square tubing cost me $206. I don't know if he is treating me good, or getting even for sleeping with his sister!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
