It's been a long time, but I will recall what I can. That set up was the major problem with those tractors. The PTO clutch system, if left with the lever latched to the rear, would push the crankshaft forward through the thrust bearing, until major engine damage resulted. That's why they offered the retrofit, external, front mounted, Timken, greasable thrust bearing.
As I recall, you were supposed to be able to pull the PTO clutch lever back, with the engine running, pull up on the PTO shifter to engage the drive line, then release the clutch lever forward, engaging the PTO. As I remember it never worked that way, without grinding the shifter. And as I recall, you couldn't start the engine with the PTO shifter engaged, because of a safety switch.
You could have any number of problems, with worn linkage, clutch, bearings, cable, etc. Anything hooked to the PTO ought to offer enough resistance to stop the PTO. If you're fortunate, some adjusting might remedy the situation. If I had kept the tractor, I would have bypassed the safety switch on the PTO shifter, so that I could start the tractor after pulling the clutch back, and engaging the shifter. Then I would still use the clutch lever properly, leaving it forward as much as possible. I wouldn't be trying to start the tractor with the PTO engaged and hooked to an implement.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.