Posted by Dave in GA on August 29, 2016 at 17:37:56 from (162.196.195.8):
In Reply to: Truck Rant!!!!!!!!!!! posted by Bill VA on August 29, 2016 at 12:35:49:
Bill, I couldn't agree with you more. Why do the new pickups, even the half ton 2WD ones, have to be so ridiculously tall? I know the truck manufacturers are all trying to outdo each other with the most manly, brawny, tough-guy, unstoppable ginormous monstrosities, but if they get any taller and more bulky, they will be right up there with Peterbilts and Kenworths. Whatever the fad is called, it's not for me. Make them reasonably sized again. Makes me appreciate my beater 1971 International 1/2 ton with 304 and 4-speed and 8' bed. The top of the sides in the rear is just under 48 inches! Perfect height to lean on to chat with somebody holding a cold drink. I can reach into the bed almost to the center. Yet this truck will haul a lot.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
