Posted by Traditional Farmer on September 06, 2016 at 23:35:43 from (76.5.76.26):
In Reply to: Zebra 3522... posted by Goose on September 06, 2016 at 20:41:25:
I had a Zebra 3520 which is almost the same as the 3522 for about 10 years bought it cheap when it only had 200 hours put about 2000 more hours on it mostly mowing hay.I liked it rode and handled good its almost an exact clone of a Zetor Model and when I had to get an injection line that cracked it was actually for the Zetor. I sold it to a dairy farmer in PA that loved them he used them to scrape in his the dairy barn said he had 9000 hrs on one and the engine hadn't been touched.I know the one I had would start right up when it was 20 degrees with no heater or starting fluid about the best starting diesel I've ever owned.Electrical system was terrible but a one wire alternator fixed that.For the right money I'd buy the one in the picture in a heartbeat,thats the original rear tires so it couldn't have too many hrs on it.The one I had was built in India,never leaked or burned oil either.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.