Posted by Billy NY on September 13, 2016 at 10:07:42 from (104.228.35.235):
In Reply to: Hay Making posted by kcollinsuk on September 13, 2016 at 02:17:22:
If there is one thing I've learned in regards to horses, is do not take chances with any kind of feed. The potential risks, in my experience, when it goes wrong, are very costly. Maybe the breed you are dealing with is not as sensitive to colic, but it sure seems the Thorougbreds we've always had most certainly are. You don't have to work very hard to have one colic, and I have been through that nightmare numerous times.
That hay is just been on the ground for too long. Bleached like straw, none of the horses we've had would likely be interested in it. It would get mashed into the stall bedding. They are really good at picking through things like hay and might find a little of it appealing, most of it would be left.
I would agree, some horses may do fine with less than average hay, and in some seasons, that's all you may have available because conditions are just not ideal, lots of rain or otherwise. Mold and dust are more of a concern than if the hay is high in feed value. You'll just feed more of it to get by.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
