Posted by greenenvy on October 16, 2016 at 07:09:40 from (216.220.12.96):
In Reply to: Re: Harvesting grains posted by Case Nutty 1660 on October 16, 2016 at 02:26:09:
We've had three 8820s over the years with one still on the farm. Seems like on those you can set the machine once at start of harvest and never touch them again and still will do a great job. The 9600 we had afterwards it seemed like we were always having to fine tune it. Then we had a CTS II which was a real cleaning SOB. So much so that our local CIH rep commented a few times how good a job it was doing. Since then we've had JD rotaries and they do a good job like I've already posted but you have to fine tune them a lot. Whoever said you have to fine tune these newer combines verse the older ones I kinda agree. I've never touched the settings on my old combines and they all do a good job. They would probably do even better if I had new cylinder bars/concave for them all.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
