I would agree this is the way to go if I can get the alternator moved and keep the axle strong. I tried last night to move the alternator but I can't figure out how to get it out of the way. Can't go up, down, in, or out even with metal fabrication. Just no room. Maybe move it to the other side since no power steering pump?
One other thing that was preventing me from moving the axle in was I can only go one more adjustment and that puts my 2 axle bolts directly next to each other. It would seem to me you would want your axle bolts spread out as much as possible especially with a loader and this type of axle, but I could be wrong. Is it fine that way with the 2 axle bolts so close together? Drill a new hole so I can spread axle bolts out?
I am curious how that doubles the stress on the bottom pins with my last idea. If I am keeping my cylinders in line with new mounting and I'm creating a straddle around the cylinder hole, there is no difference on stress to the pin. I could see if I simply move the cylinder to the outside and stuck a pin through with no outside pin support fabricated. My idea has pin support on both sides of the cylinder mounting hole.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
