Posted by Billy NY on October 31, 2016 at 10:18:38 from (104.228.35.235):
In Reply to: New Driveway Question posted by John B. on October 31, 2016 at 04:06:18:
Crusher Run (Item #4) is what its called around here, its a composite mix of crushed stone and fines with a certain size passing through a sieve, 3/4" if I recall. This material is NYS DOT approved sub-base for roads. Depending on your ground conditions, it may be all you need, grade and compact in 12" lifts over existing if its suitable. For larger/deeper fills, there are lots of types of run of bank gravel you can use before topping off with crusher run for either a wear surface or sub-base for some kind of pavement ie; bituminous asphaltic concrete, (asphalt paving) or say concrete itself.
Key things are drainage, determining if existing undisturbed is suitable to build up on or you need stabilization fabric to overcome existing conditions etc.
Clean 3" stone with no other sieve size passing through, just the 3" stone, is not going to compact because you need an array of aggregate/fines to achieve that with optimum moisture levels. Same is true with fine sand, it can be settled with water but you you would never build a pad for a slab or use it for a sub-base for a driveway, again it needs a composite amount of various sieve size aggregate with optimum moisture to compact and be able to support the intended loading properly.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
