Posted by nrowles on November 01, 2016 at 05:27:54 from (71.251.155.138):
Again, I am new to a tractor of this size. I have a MF135 and just got an old Davis 102 loader installed. It is light on the rear.
I am hesitant to load the rear tires at this point because it is expensive, I haven't used the tractor enough yet to invest money into filling something that could potentially leak out, and out of the blue at one point a couple of months ago one of the tires went completely flat overnight. Put air in and it has been fine since. Just not ready to do this yet.
I was going to use my box blade as a counterweight just to have a usable component hanging off the back but it only weighs 400lbs which isn't enough.
For about $75 I can fill a 55 gallon drum 3/4 full of concrete and install the necessary pins and what not. This should put me around 900lbs. I have seen some comments online where guys have done this but made the counterweight more usable. Put a couple pvc pipes vertically to use for long handled tools such as shovels, rakes, etc. Install a hitch receiver. Only fill 3/4 full so there is room in top for chains or whatever else will fit.
What is your opinion on the concrete barrel counterweight and the fabrications to make it more of a usable tool rather than just a weight? What does hanging something this heavy on the back of the tractor on a constant basis do to the way it handles?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
