Posted by Texasmark1 on November 02, 2016 at 05:37:04 from (184.63.170.145):
In Reply to: Seal with spring posted by JimS on November 01, 2016 at 19:24:45:
I agree on pressing in when you can.
Pressing helps to keep the installation vertical.
Plunger should be sized to emphasize or at least cause equal pressure on the OD of the seal.
On outboard motors, they recommend a thread locker for installing a seal. 2 events here: 1. The locker provides initial lubrication for the insertion. 2. It provides a film to seal any tiny imperfections in the mating surfaces. Auto parts stores carry it . Blue is what I use for everything. The Mercury OB manual recommends red. Well fine. Red is for permanent applications. If that suits you ok. But if you plan on keeping it for a long time, which most of us do, then at some later date you will be back in with another seal and blue will be much more friendly in cooperating with the change.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
