Posted by Bruce from Can. on November 24, 2016 at 15:19:23 from (70.52.185.7):
In Reply to: Re: whitewash posted by Dick on November 24, 2016 at 13:58:09:
Hi Dick, My whitewash rig is quite simple really. I used a 100 gallon Rubbermaid water trough that I had, and bolted some old boards across the middle . I then bolted a small jet pump , the kind that is mounted on it's own pressure tank , and comes complete with a pressure control switch. Plumbed a pipe with a foot valve down into the trough , about a inch off of the bottom . I just fill the trough about three quarters full of water , and add 2 bags of spray lime per batch. I use a Dry wall mortar stir paddle, in my half inch drive drill . Stir till I figure it is mixed well . Prime the pump before you mix in the lime. I use 100 foot of garden hose with a spray wand that I picked up at a garden center. The wand I have has a shut off on the handle , so if I need to stop spraying to pull hose or move to the other side of the barn , I can just shutoff the flow. None of this stuff cost too much , and is all available from a hardware or feed store . Some things to remember with white washing, Lime will burn your skin , and your eyes, wear some protection . Also fresh white wash doesn't look very white until completely dry, maybe a day or two after you spray it will look much whiter than the day you sprayed it on . And be sure to cover any thing you don't want white, hard to wash off once dry. Bruce
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.