Posted by Adirondack case guy on December 07, 2016 at 08:16:41 from (74.69.160.79):
In Reply to: case eagle hitch posted by ericlb on December 07, 2016 at 06:58:00:
There are 4 parts to a Case eagle hitch arm. (1) the arm itself with the hook shaped jaw, (2) the sliding latch assy mounted with pin and clips, (3) the lock tab, also held in place with common pin, and (4) a flat spring missing in pic, which prevents the lock from flipping up if jolted hard. With the lock flipped up, (It has a light chain or rope attached that operator can reach from seat) the latch can be slid forward by backing against the implement pin. and then raise arm slightly so pin bottoms in latch and then pull forward and the implement pin is locked into the arm at which time the lock also drops back down so latch can not slide ahead and open. The light leaf spring I which is visable in first scan of lit. acts to hold the lock dowm when implement is hooked. Also take note that Case eagle hitch arms do not move laterally. They are fixed width for Cat I 3pt implements. The pics taken are of my 1963 Case 831C which my dad ordered in for one of the uncles. It was hooked to a Cat II Case JTA plow so we heated and spread the arms and ground out the latches to accomidate the larger1"pins. Also someone has put the now broken locks on the wrong side. There are RH and LH locks. I have new ones plus the springs to properly replace them. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
