I hope you insulated the perimeter of the slab vertically down at least 2ft. If not, you are just transferring heat into the ground outside. What size tubing did you use ??? should be at least 7/8" for a slab that size and that spacing. It is near imposable to transfer a lot of BTUs through smaller 1/2" pipe, especially the footage you are using. If it is 1/2" tubing there is very little heat transfer at the end of the system loop, unless you have several loops with pumps on each. Recovery time is much longer, but will eventually get to the temp you want. When we were building commercial buildings we had "Radiant Tech" in Vermont design, spec, and supply all our materials. never had a complaint with heating big shops. Once you have the ceiling and interior walls in with proper insulation, you will notice a big difference. Radiant heat doesn't rise to the ceiling like conventional heating systems. It stays in the lower zone close to the floor, up to about 8-9' high. No need to install ceiling fans with radiant floor heat. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
