designed so back wheels on ground,, first off. the rear cutting height is set by the rear wheels and they help the shredder run over uneven ground with out scalping.
second.. top link set so shredder is level, but no slack in the top link. so that when you lift it, the rear will raise higher so it does not hit the drive shaft and ruin it.
After this... the shredder should be run normally level...
if heavy grass, run the shredder slightly high in front, so the front will cut it first and the rear being lower will cut it again. this will take more power as your cutting it twice but will clean better.
If low on hp, run shredder with rear wheels set to hold the rear up higher so that only the front cuts and the rear does not.
Again, if everything normal, run it level, with rear wheel setting the cutting height, the front raised up to match, and the top link having the slack taken out...
running with back wheels off ground, over rough terrain, will eventually break welds and joints on the shredder especially the larger ones due to the weight of the shredder bouncing against its frame support at the front only. rear wheels on ground means shredder weight is supported from the front and the rear and weight is cut in half on the supports. dual rear wheels even move share the load when one if off the ground the other still supports the rear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
