As mentioned, you can pull the dist with two bolts removed. this will allow you to also check the dist shaft bushing while it''s out, which is a common wear item that often affects point gap, thus spark timing, and voltage. The problem with this method is registration of the dist shaft upon install. I recommend getting a piece of paper, and make a diagram of the offset slotted drive as removed. note where the housing comes off, and where the offset ridge is when it''s removed from the engine. It must go back in the same way on the gear so that the offsets match.
If the dist won''t drop in fully, that''s an indication that the shaft is not registered properly. Once off, replace all the wear components, and check the shaft for play. If it needs a new bushing they are avail as well. You can also switch over to the Pertronix ignition plate which comes in either 12 or 6 volt models. No points. I would also replace the coil at the same time. Parts are readily avail from just 8n's at decent prices(no affiliation).'
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.