Posted by 2underage on January 26, 2017 at 09:52:41 from (64.19.81.242):
I decided that I needed to start my Oliver 1800 and move it to a place where it would not be in the mud when the frost leaves the ground. Tried to start it but it turned slow so I put the charger to it or about 30 minutes and tried again. No go, turned no faster than before so I gave it another 30 minutes and tried again and this time it cranked fast for a couple of revolutions and back to just grunting.
I finally walked away and went on to some other projects and almost forgot that the charger was still connected to the tractor. When it occurred to me that I was still trying to get the old tractor running so back I went. This time it spun over rapidly but it did not fire. My wife who was watching me suggested that I was out of fuel but I did notice some smoke from the stack so I was pretty sure I had some fuel. Next I tried a little starting fluid but that did not seem to help so I decided not to use that anymore.
Well, very 10 minutes or so I gave her a whirl and finally it sputtered a few times and finally started. I quickly moved it to its new parking spot and sat on it to let it run for a few minutes to warm it up good when it began to sputter and act like it was going to stall so I shut it off. Took a look in the fuel tank [diesel] and sure enough my wife was right again.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
