Start with this: antenna ratings by mileage are nothing more than smoke and mirrors. Why, you ask?? Because there is no reliable way to predict reception range. Current TV signals are on the UHF band. Signals of such a high frequency are pretty much strictly "line of sight" from the tower to the receiving antenna. So, having said that, the variables that come into play are the heights of the transmitting tower and the receiving antenna. The higher the tower, the longer the range. The higher the receiving antenna, the better and more distant reception you will get. In your case, I would suspect that your pre-amp is either on the antenna or at some remote location. I suspect that it is not getting power. A pre-amp does not make a good pass-through device, and would seem to result in the problem you are having - less stations with the pre-amp than without. Next possibility is that something is somehow causing leakage of the signal. A bad piece of coax? Wrong impedance coax? Center conductor bent and not making proper contact somewhere in the system?
I suggest that you start by verifying that you actually have power to the pre-amp. Then check all of your coax connections. After that, look for a "leaky" piece of coax. There is a lot of potential for "critter damage" to a 200 foot run of cable.
BTW, there is no better brand of antenna equipment than Winegard. They are the Rolls Royce of antenna and reception equipment makers.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.