Posted by FarmallCT on February 08, 2017 at 12:07:17 from (50.28.149.116):
Hi guys,
I am currently looking at buying an antique Ensilage/Forage Cutter built by Case. I am trying to figure out what it is worth.
I did have a much older Papec built ensilage cutter about 4 years ago that we pulled out of the woods before I got into the big tractors, and I know we couldn't even manage to give it away so that went to scrap sadly. Was in a bit worse condition but not by much. Pictures of that are included at the bottom.
The guy is asking $200 for it which seems like an okay price but given my experience where I couldn't even give one away it seems high. It's about 2 hours away just north of Albany, NY.
What would be a fair price to offer him for it? He thought he could get $300 for scrap but I doubt he could get $100, since I know they weight a decent amount, but not much more than a ton I don't think.
Also does anyone have any other information on these ensilage cutters such as year and what exactly to use them for? I don't know too much about them, but would like to try and save this one and eventually use it at shows for demonstrations now that I actually have tractors to use with it.
The first 3 pictures are the Case ensilage cutter that I am looking at buying, the last 5 are the one I had 4 years ago.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
