Posted by Bkpigs on February 22, 2017 at 19:10:46 from (104.240.108.121):
A while back I asked what was needed to add float to a Gresen 2702. I got a dirty 2703 from my FIL that has float on two of the spools. I was looking at the casting and it looks like they are all the same with the exception of an extension on the ones with float. They look like the casting is the same and the extension is an add-on.
The confusion I have is, on the spools without float, an end plate is held in by a retaining clip and the bore is smooth as far as I can tell. How is the extension held in there and can I remove the one float from the 2703 and put it on the 2702? Right now the 2703 is caked in old oil and dirt so I can't get a clear look at it until I get a chance to pressure wash it.
Also with the 2703 being wider I would need to add an extension to my pedestal I made for the spools to sit on the IH 504.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
