Posted by BobReeves on February 23, 2017 at 05:42:16 from (70.184.16.104):
During the process of resurrecting a JD 247 planter I have ventured into a couple areas I had never played with before. I like learning new stuff even though I'm in my 70's it's still fun and challenging.
Babbitt bearings. Decided to fix the wallowed out counter shaft bearings by pouring Babbitt metal in around a 3/4 inch plug I made to fill in what had been ground out of the original bearings. Had to learn about all the different Babbitt alloys and how to pour a bearing. Ended up working better than I expected.
Now in the process of learning about spring steel and how to temper for the proper hardness. The lids for the seed bins were in pretty bad shape with the spring hold down clips broken off. Decided to make new spring hold down clips using spring stock from Brownells. 1/2 inch wide X 1/16 annealed stock. Once I get the hole drilled and the spring bent to shape they will need to be hardened and tempered.
To me this is fun stuff different than the normal welding, fabricating and machining that goes into a project like this.
What new disciplines have you acquired in the process of completing a larger project.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
