Posted by kcm.MN on February 24, 2017 at 14:48:10 from (174.219.5.3):
In Reply to: Cleaning out a pond posted by pinball on February 24, 2017 at 10:20:44:
I've been hesitant to reply to this post, but can't help but ask this question but - seems to me it wouldn't be very difficult to make a float for a 3" or 4" gas trash pump to float on, as well as making a sort of dust hood that skims along the bottom. The pump could pick up silt and water, wash it up on shore and then the water could filter back to the pond through a row of hay or straw. As your tailings build up, let them drain for a little while, remove the silt to another area and go another round.
Could maneuver the suction skimmer using rope from shore or maybe use a makeshift boom mounted to your skidloader or other. When you're done, you'll still have a good trash pump and the hoses. Also, you could check with local fire departments to see if they have any old hose that needs replacing, or maybe that you could borrow in exchange for a donation (if it's volunteer).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
