Depends entirely on your soil. In places they will handle 3-14" easy, in places you would only want 2 bottoms. Now if you have the remote hydrolic system on your tractor it should work fine with a pull type plow. Now a clutch lift will also work but that is where you get into the situation the other poster mentioned. Your biggest problem will be traction as that is not a heavy tractor and small tires. You need the tires filled with the heaviest fluid you can get, no washer fluid as it is light in weight and at least 1, perhaps more sets of wheel weights. I had a Ferguson TO30 that I pulled a 2-12" plow with, it was a clutch lift that we converted over to cylinder lift and it worked OK on both type of lifts. On the TO30 we had it set up for the remote cylinder. It did need an engine overhaul tho. My problem was I just had the fluid in the tires and as long as I stayed at half throtle I was OK, if I opened it up then it would start to spin that left tire. If I would have had wheel weights then no problem. Remember there was only one kind of fluid avaible back in 1969 when I had this setup.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
