Nebraska had an inspection law about 20-30 years ago and finally repealed it. We have no inspections now, and obviously law officers have the authority to cite and report vehicles that appear to be unsafe.
The problem with Nebraska's law was the authorized inspection stations were also repair shops, so you could predict the results. Some were honest, but a lot of them yielded to temptation and found all manner of things that their shop would need to repair before they would pass the vehicle.
The most fair and efficient system I've seen was in Memphis, Tennessee years ago. The inspectors were government employees who had no stake in whether a vehicle passed inspection or not. When you drove into the inspection bay, you drove onto a rack that checked the braking power of each wheel and compared it to the other three to check the brakes. You stayed in the vehicle and the inspector then did a walk-around of the vehicle, asking you to toot the horn, turn on your wipers, turn on your headlights and flash the high and low beams, checked the tail lights and turn signals, etc. While the inspector walked around the vehicle he was looking at window glass and other safety issues. Assuming the vehicle passed, the inspector then put a new sticker on the lower right corner of the windshield.
The whole thing took only a few minutes and the fee was minimal. I don't know if they're still doing it that way in Memphis or not.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.