Posted by david from kansas on April 10, 2017 at 05:59:05 from (199.58.181.49):
In Reply to: Mile Markers posted by MT RON on April 09, 2017 at 20:42:53:
In Kansas, the only place I have seen them every .2 mile is near Wichita, but I stay as far away from the K.C. area as possible. Also agree that they are a waste of money. Also, too many farmers inching out into the highway right-of-ways so now the tax payers are buying thousands of highway markers so the farmers can tell how far they can go. One farmer near me has utility poles about 40 feet into the field and he was constantly spraying around the poles out onto the pavement, killing all the vegetation on the right-of-way. Took about 10 years of this for the DOT to react with signs about every 200 ft or so. I just think it is a shame that the tax payers are having to pay for the ignorance of some farmers. This same farmer has removed every old fence along the property line along the state highways so he csn gain a few more inches of farm ground. Some people are pretty greedy. END OF RANT.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
